Fabric weight standard test method for Mass Per Unit Area (weight) of fabric using ASTM Test Method D ASTM D Standard Test Method for Mass Per Unit Area (Weight) of Fabric1 – Download as PDF File .pdf), Text File .txt) or read online. ASTM D The ASTM D Basis weight test method covers four methods for the measurement of fabric mass per unit area (weight). It is applicable to most fabrics.
|Published (Last):||27 November 2016|
|PDF File Size:||4.22 Mb|
|ePub File Size:||20.38 Mb|
|Price:||Free* [*Free Regsitration Required]|
Option C on the other hand is applicable when a small astm d3776 of fabric is sent to the laboratory to be used as the test specimen.
This abstract is a brief summary of the referenced standard. Astm d3776 second option is Option B which is applicable to a full-width sample cut from a full piece, roll, bolt, astm d3776 cut.
These test methods cover the measurement of fabric mass per unit area weight and is applicable to most fabrics. Link astm d3776 Active This link will always route to the current Active version of the standard.
Fabric Weight ASTM Test Method D3776
astm d3776 ASTM does not give any warranty express or x3776 or make any representation that the contents of this abstract are accurate, complete or up to date. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not astm d3776 as part of the standard.
Unless otherwise specified, astm d3776 results will include selvages astm d3776 will be on the basis of conditioned fabric. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D – 96 Standard Test Methods for Mass Per Unit Area (Weight) of Fabric
It is informational only and astn an official part of the standard; the aastm text astm d3776 the standard itself must be referred to for its use and astm d3776. Option A may be used for acceptance testing of commercial shipments since it has been used extensively in the trade.
Historical Version s – view previous versions of standard. Astm d3776 last option is Option D which is intended for use with narrow fabrics as so designated by the trade.
The results are considered to be applicable to the sample only and not necessarily to the lot from which the sample was taken. Work Item zstm – astm d3776 revisions of this standard. Measurements by this method astm d3776 not include selvages and should be reported as such, unless a selvage allowance is specified.
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance astm d3776 the standard.
There are four approved options astm d3776 the measurement of fabric mass per unit area: